Item Description Features 1.9-speed power adjustable, five-level power display. Simple and convenient, powerful 2.5V charging, more convenient to use 3. Spot welder send nickel belt, one-handed, convenient to use 4. Charging display, buzzer alarm, more secure 5. Support 0.1~0.12mm thickness nickel piece, intelligent identification, automatic welding, simple and convenient operation Specification Maximum output current up to 1200A Fully charged can continuously weld more than 1000 times Five power levels can be adjusted, short press button control, blue light indication Charging port: USB plug charging Charging voltage: 5V input (higher voltage input is strictly prohibited) Charging current: 1A (5V/2A charger recommended) This product supports charging while using, the remaining power indication: green (high), green flash (high), red flash (low), red (low), the red light is on must be charged to work. Low power will affect the welding effect Switching instructions Short press to power on Long press to shut down 6 minutes without any operation will automatically shut down Note Copper, aluminum surface can not be welded, rusty surface can not be welded, smooth stainless steel surface can be welded normally. Part of the battery an electrode is stainless steel, an electrode is aluminum, our spot welder can weld stainless steel electrodes, aluminum electrodes need ultrasonic welding, please note. Remind again, aluminum electrode, copper electrode can not be welded. Common 18650, 32650 and other round batteries can be welded. The two needles are steadily pressed on the nickel piece before output welding, lift, and then weld next time. Instructions for use Spot welding nickel sheet 1. the battery should be fully charged, must be fully charged, spot welding nickel sheet, the thickness can not be thicker than 0.12MM. 2. spot welding attention to the pressure. The harder you press, the less heat; the lighter you press, the greater the heat; but too light will be perforated, too heavy and point not firm. So you need the right strength, do not press too hard. 3. the battery should be polished smooth, remove the surface of the oxide layer and uneven. Solder pen if oxidation black, please use fine sandpaper polished smooth. 4. 4. Use the most pointed point of the pen, so that you can also point firmly. Welding method: Visualize the welding tip, and the horizontal plane into 60 ° grip, two needles at the same time pressed in the nickel surface pressure, good contact, current flow from one needle to the other needle, high current melting nickel, so that the battery and nickel welding success. List 1 x Spot welder 1 x Nickel strip 1 x USB charging cable Payment Shipping Refund Payment We accept PayPal only. But we only Accept your Ebay Address ,Please Make sure it's 100% right. Payment must be received in 5 business days of auction closing. Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order. Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched. Shipping Fill your shipping info Refund All package need to wait 30 days (US only need 7-10 days) , Please take care it.Less than 30 days,we can't take a refund . If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it. If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.
Returns Accepted for this item if it's within 30 Days